![windows xp embedded support lifecycle windows xp embedded support lifecycle](https://images.saymedia-content.com/.image/ar_1:1%2Cc_fill%2Ccs_srgb%2Cfl_progressive%2Cq_auto:eco%2Cw_1200/MTc0MjkzNTM0NzI2MTcwMTA4/how-to-safely-use-windows-xp-after-microsoft-ends-support.jpg)
- #WINDOWS XP EMBEDDED SUPPORT LIFECYCLE INSTALL#
- #WINDOWS XP EMBEDDED SUPPORT LIFECYCLE UPGRADE#
- #WINDOWS XP EMBEDDED SUPPORT LIFECYCLE SOFTWARE#
#WINDOWS XP EMBEDDED SUPPORT LIFECYCLE INSTALL#
But like other suggest, it depends on your hardware specification and how old it is if you can install (and properly use) Windows 7 or greater.
#WINDOWS XP EMBEDDED SUPPORT LIFECYCLE UPGRADE#
You won’t be “locked in” to using POSReady 2009 - but you just need to install fresh Windows using installation media and select the option for clean / fresh install as you can’t upgrade from POSReady 2009. You need to wipe it and install a fresh copy of Windows 7 or above. If you already have an old system with POSReady 2009, you cannot upgrade it yourself to POSReady 7.
![windows xp embedded support lifecycle windows xp embedded support lifecycle](http://www.gieseke-buch.de/wordpress/wp-content/uploads/2009/10/lifecycle.jpg)
There is no way you can use SambaPOS V5 or V4 on Windows Embedded POSReady 2009 (or Windows XP).I have no problem updating windows to windows 7 but wonder if it is possible on this But if you are setting up yourself, you don’t have this option so must use retail / OEM or similar licensed versions of retail Windows.Īm hoping that I could get it on the embedded version. There are some other benefits of POSReady I won’t go into here and you can read about online, but for SambaPOS it is a good OS to use if you are purchasing POS hardware from a supplier as the cost of OS will be less. You can get around this but you need to install windows components via command line. This is good for a support angle, but not ideal for end user who is IT proficient. Also, because the system builder is put in control of what windows components are available, end user cannot access windows components from Add/Remove software.
#WINDOWS XP EMBEDDED SUPPORT LIFECYCLE SOFTWARE#
I never had any problem with installing software needed for using as a POS. However I have found POSReady 7 some normal software like MS Office will not install, I never researched further about this but found out from client feedback. POSReady 2009 (XP version) was a lot better for general software compatibility (e.g. So, when we sell a new system, we just write the image to the system, and it’s pretty much ready for SambaPOS customisation in 20 minutes. Our image is of the OS, plus all drivers, configuration, support software, MSSQL Server, SambaPOS. Each system does not require activation (therefore a very convenient time saver), and for us, once we have our master system set up, we take a disk image of it using Microsoft’s free ImageX utility. For a system builder, you get a master install of POSReady which you then use to configure your general install for each hardware you use. Therefore, there is no installation media for end user. if system needed reinstall they need either to go back to where they purchased from or install a retail version of Windows from scratch). The per system license cost is much lower than retail versions, but the end user cannot reinstall the system (i.e. We use POSReady 7, but needed to work with our supplier to purchase the licenses for each system we sell. You cannot buy Embedded versions, they need to be installed by the manufacturer / OEM or system builder. POSReady has different licensing than retail versions of Windows.